Hi,I am following the instructions in the Platform Builder 3.0 "Getting Started".
PB 3.0 running on NT.
CEPC: BIOS Phoenix 4.05, (4.06 to)
The BIOS Settings "PCI IRQ line 1", "PCI IRQ line 2"... are setting to Auto Select.
NIC: 3COM Etherlink XL PCI COMBO (3c900) (or 3Com Fast Etherlink XL PCI to)(3C905B-TX)
I have added the NDIS Driver to the CE-Bootdisk. The Driver started successful.
(IRQ=9 und BaseI/O=CFF0 are displayed on the CEPC, the same Setting are in the Autoexec.bat,Adress configure aut. from DHCP, The Host PC and CEPC are on the some Subnet). Ping from Host ist ok.
After this started the Loadcepc.exe.
I get the "Jumping to 0x001332B58" Message and my CEPC crashes. I am unable to get ethernet connection to PB from CEPC. CEPC device name does not appear in the NEW DEVICE Box.
After this i am traying to boot parallel via Null- Modem Kabel.
PPshell Service is started automatically (Regestriesettings for cepc, LPT Mode is bidirectional, Base I/O 378, IRQ 7 on CEPC and Host PC). The Servises Parallel ParPort und ParVdm are as manuell configured und stoped. I get the Message from CEPC:
Sening boot Packet:aa
Wait For Status: PPSH disconnected
Thanks in advance!
Konstantin